Thingiverse
Handle
von stef_nouws
2
Downloads
6
Likes
0
Makes
Part Description:
This component is a drawer handle, designed as a separate part. The handle is shaped for ergonomic grip and intended for mounting on a flat surface, such as the front panel of a drawer.
Mounting Method:
The handle is attached using two mounting holes with a diameter of 3 mm. These holes are spaced 115 mm apart (center-to-center distance). Mounting is typically done using two screws, inserted from the inside of the drawer front into the handle.
To install properly:
Drill two holes in the drawer front, 115 mm apart (center-to-center),
Align the handle with these holes,
Insert and tighten the screws securely to ensure a firm attachment.
This component is a drawer handle, designed as a separate part. The handle is shaped for ergonomic grip and intended for mounting on a flat surface, such as the front panel of a drawer.
Mounting Method:
The handle is attached using two mounting holes with a diameter of 3 mm. These holes are spaced 115 mm apart (center-to-center distance). Mounting is typically done using two screws, inserted from the inside of the drawer front into the handle.
To install properly:
Drill two holes in the drawer front, 115 mm apart (center-to-center),
Align the handle with these holes,
Insert and tighten the screws securely to ensure a firm attachment.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
