Thingiverse
Hat Face Shield
door iznougudpt
7
Downloads
10
Likes
0
Makes
Face shield adapted to be used with a regular hat.
The holes are 80mm apart.
Use Tree Support. The hole in the top is there to allow the support to reach the upper part and provide better support.
I printed this with a 0.6 nozzle at 0.4 layer height and 0.6 line width @ 60mm/s.
4 Wall and 2 Top / Bottom with 20% infill.
I printed this in PLA but reccomend PETG or ABS to endure a hot day.
The support should hold well on it's own but added 2 small hooks to help secure it in place. Just use a rubber band to adjust it to your hat.
The holes are 80mm apart.
Use Tree Support. The hole in the top is there to allow the support to reach the upper part and provide better support.
I printed this with a 0.6 nozzle at 0.4 layer height and 0.6 line width @ 60mm/s.
4 Wall and 2 Top / Bottom with 20% infill.
I printed this in PLA but reccomend PETG or ABS to endure a hot day.
The support should hold well on it's own but added 2 small hooks to help secure it in place. Just use a rubber band to adjust it to your hat.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
