Hat Face Shield

Face shield adapted to be used with a regular hat.
The holes are 80mm apart.

Use Tree Support. The hole in the top is there to allow the support to reach the upper part and provide better support.

I printed this with a 0.6 nozzle at 0.4 layer height and 0.6 line width @ 60mm/s.
4 Wall and 2 Top / Bottom with 20% infill.

I printed this in PLA but reccomend PETG or ABS to endure a hot day.

The support should hold well on it's own but added 2 small hooks to help secure it in place. Just use a rubber band to adjust it to your hat.