Thingiverse
Hatchbox Spool Insert
von Boseveous
5
Downloads
2
Likes
0
Makes
Designed for Hatchbox, but will fit a variety of spools if flipped around. Simply hold in place with a few dots of superglue. Once the spool is exhausted, pry off for reuse!
Inner hole is designed for 20mm spool holder rods.
Inner hole is designed for 20mm spool holder rods.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
