Thingiverse
HDZero Goggle Patch Antenna Mount (captive)
by peos3
9
Downloads
11
Likes
1
Makes
A HDZero goggle antenna mount for the TrueRC patch antennas. The mount is captive (no adhesive needed).
Make sure to add a piece of foam between the backside of the antenna and the goggle front surface to prevent scratches from the solder connection point on the back of the antenna. (see pictures).
This is a remix of the model from [Cwchapma](https://www.thingiverse.com/Cwchapma).
Following the example of [etnnn](https://www.thingiverse.com/etnnn) I removed the rounded corners and replaced them with some beveled edges (ensuring better printability). I also added some rounded corners to the cable entries and reworkes the sides (now only 1.5mm thick).
Step file for further adjustments available.
Make sure to add a piece of foam between the backside of the antenna and the goggle front surface to prevent scratches from the solder connection point on the back of the antenna. (see pictures).
This is a remix of the model from [Cwchapma](https://www.thingiverse.com/Cwchapma).
Following the example of [etnnn](https://www.thingiverse.com/etnnn) I removed the rounded corners and replaced them with some beveled edges (ensuring better printability). I also added some rounded corners to the cable entries and reworkes the sides (now only 1.5mm thick).
Step file for further adjustments available.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
