Thingiverse
head
von tomassimicek
0
Downloads
0
Likes
0
Makes
A head cut in two.
I created model of this head in online SW called SculptGL. https://stephaneginier.com/sculptgl/
I exported it into Prusa Slicer 2.5.0.
https://www.prusa3d.com/cs/stranka/prusaslicer_424/
Then I've cut it in two pieces and sliced in the same slicer.
And printed it on Prusa i3 MK3S using Prusa Tansparent PLA filament.
This was a school project
I created model of this head in online SW called SculptGL. https://stephaneginier.com/sculptgl/
I exported it into Prusa Slicer 2.5.0.
https://www.prusa3d.com/cs/stranka/prusaslicer_424/
Then I've cut it in two pieces and sliced in the same slicer.
And printed it on Prusa i3 MK3S using Prusa Tansparent PLA filament.
This was a school project
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!