Thingiverse
Headset+controller Stand
von BackupTick
700
Downloads
781
Likes
10
Makes
Stand for 1 controller and 1 headset.
Since I'm getting a new computer I wanted to make a stand for my Xbox controller and my headset. So after a little while I came up with this design, which I made using Solidworks. After 3d printing the six parts with my Creality Ender 5 Plus I put them together and made my headphone+controller stand.
For several parts supports are needed. Rafts are optional, but not necessary.
The stand is 310x170x340 (length x width x height)
Since I'm getting a new computer I wanted to make a stand for my Xbox controller and my headset. So after a little while I came up with this design, which I made using Solidworks. After 3d printing the six parts with my Creality Ender 5 Plus I put them together and made my headphone+controller stand.
For several parts supports are needed. Rafts are optional, but not necessary.
The stand is 310x170x340 (length x width x height)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
