Thingiverse
Heltec wireless tracker case.
door BotMeka
16
Downloads
39
Likes
0
Makes
The case inside has two compartment that can fit in an external GPS 15mm x 15mm antenna and a BME280 sensor module 10.7mm x 13.5mm.
The main board desolder 2.4Ghz coil antenna and solder at back of board and secured the board with hot glue at 4 corners,leds status inspection holes can use a small drop of clear UV glue to fill up the holes,18650 battery holder with smd type and removed both end solder tabs and seal with hot glue.
The main board desolder 2.4Ghz coil antenna and solder at back of board and secured the board with hot glue at 4 corners,leds status inspection holes can use a small drop of clear UV glue to fill up the holes,18650 battery holder with smd type and removed both end solder tabs and seal with hot glue.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!