Thingiverse
Hemera HyperCube Mount
von sg_dev
8
Downloads
4
Likes
0
Makes
I wanted to mount the E3D Hemera to my newly built HyperCube 3D printer.
Since I could not find a suitable mount I designed my own.
It integrates with the original carriage of Tech2C.
The design is inspired from [1] also mounting the blower fan to the back of the carriage.
The fan diffuser was taken from [2] (a remix of [1]) - reducing its length to suite this design.
It features a Bltouch mount at the right back.
The mounting offsets I use are:
- X: 39.55 mm
- Y: 57.62 mm
- Z: 0.875 mm (calibrated during first use by deploying the pin and slowly lowering the z axis).
At least the FanDiffuser should be printed in a higher temp material (PETG, ABS, etc.). I also printed the MountingPlate in PETG. For the other components PLA is fine.
[1] https://www.thingiverse.com/thing:2617424
[2] https://www.thingiverse.com/thing:4202860
Since I could not find a suitable mount I designed my own.
It integrates with the original carriage of Tech2C.
The design is inspired from [1] also mounting the blower fan to the back of the carriage.
The fan diffuser was taken from [2] (a remix of [1]) - reducing its length to suite this design.
It features a Bltouch mount at the right back.
The mounting offsets I use are:
- X: 39.55 mm
- Y: 57.62 mm
- Z: 0.875 mm (calibrated during first use by deploying the pin and slowly lowering the z axis).
At least the FanDiffuser should be printed in a higher temp material (PETG, ABS, etc.). I also printed the MountingPlate in PETG. For the other components PLA is fine.
[1] https://www.thingiverse.com/thing:2617424
[2] https://www.thingiverse.com/thing:4202860
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
