Thingiverse
Hex bits case
von mray190_
29
Downloads
15
Likes
0
Makes
Store up to 60 hex bits (standard hex bit size of 1/4") in this container. Use magnets to make sure the hex bits don't fall out of the container if not using the lid.
2 options for storage:
1. Print the base and bottom for storing inside a drawer or mounting to surfaces with magnets
2. Print all 3 parts (base, bottom, lid) for putting inside a tool bag or backpack to carry around with you. No magnets necessary
Works with 15mm x 3mm or 15mm x 2mm magnets from ebay or Amazon
Printed with 0.2mm layer height, no rafts or supports.
2 options for storage:
1. Print the base and bottom for storing inside a drawer or mounting to surfaces with magnets
2. Print all 3 parts (base, bottom, lid) for putting inside a tool bag or backpack to carry around with you. No magnets necessary
Works with 15mm x 3mm or 15mm x 2mm magnets from ebay or Amazon
Printed with 0.2mm layer height, no rafts or supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
