hex driver holder

Two different holders for metric hex drivers. Both are modeled upside down to get the nice textured surface orientated up when it's done. Some printers may struggle with the overhangs, so use caution and rotate based on personal preference

The holes for the shafts are somewhat precise to allow for a good fit without wobbling around excessivley. These holders could be used for any other drivers, if you don't mind drilling out the holes a bit. The holes are all 60mm deep to allow a decent amount of engagement with the tool.

holder for a set of 4 allen drives in ball and straight models, the specific set its designed for are:
straight: https://www.amainhobbies.com/align-hexagon-screw-driver-set-1.5-2.0-2.5-3.0mm-agnhz024/p18527
ball: https://www.amainhobbies.com/protek-rc-trutorque-sl-metric-hex-driver-set-4-ptk-8416/p863873

Also, a holder for a 7 piece set of metric drivers. The specific drivers this is modeled for can be found located here:
https://www.amazon.co