Hexadic- TP3 style Y6 prototype

this is my take on a toothpick 3 inch style Y6 frame. PLEASE.... use this to inspire your own designs because im excited to see what you all can come up with. i designed this to just try it and i know the frame can be better optomized but im new to 3d designing with fusion360. ive cut this in carbon.

the body is 2mm thick. just need one
the LR front motor plates is the same left and right depending on how you flip it. youll need 4 at 1.5mm
the tail motor plate you just need 2 at 1.5mm
and the plate is 1.5mm and only need one.. it is essentially a way the drone can sit off the ground so props can be clear to spin up. also it helps protect the FC stack.


the motor plates uses m2 screws and a nylon lock nut. total carbon thickness where its needed to go through is 5mm.

the flight controller used is the flywoo hex 16x16 stack. the camera is the ant nano.
elrs rx. vtx came with the stack.


again this is a prototype and i dont plan to make any more changes, im more excite