Thingiverse
Hinge
24
Downloads
20
Likes
0
Makes
Originally designed for an ultimaker 2 enclosure I was building.
The hole spacing is 25mm by 30mm
Requires:
1 x 35mm bolt
1/2 x m3 washer (for the removable and fixed design respectively)
There are two versions, one that can be slid apart easily and one that is fixed. Both use a m3 washer (1mm thick) to act as a small bushing.
Best printed with supports - touching build plate
The hole spacing is 25mm by 30mm
Requires:
1 x 35mm bolt
1/2 x m3 washer (for the removable and fixed design respectively)
There are two versions, one that can be slid apart easily and one that is fixed. Both use a m3 washer (1mm thick) to act as a small bushing.
Best printed with supports - touching build plate
TinkerLifeProjects veröffentlicht auch auf
9 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
