Thingiverse
HOLDER SD+2SD
von dj55nava
4
Downloads
1
Likes
0
Makes
Support for SD card adapter, my printer has the sd card input on the back and it is very annoying to change the card, buy an SD extender and design this support to easily access.
the width to enter the printer it is 8mm, if it is smaller we can fit a nut and screw of 3mm in the piece, see photos.
It also has two spaces for sd cards on top
the width to enter the printer it is 8mm, if it is smaller we can fit a nut and screw of 3mm in the piece, see photos.
It also has two spaces for sd cards on top
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!