Thingiverse
Hondata FlashPro Case
von mbrej
6
Downloads
6
Likes
0
Makes
Printed with solid infill because it's fairly thin. Took about 6 hours on my neighbor's Ender3. Not too sure how many grams.
Designed this in SolidWorks using a ruler to measure the FlashPro's dimensions. I chose to err on the side of too big over too small, so used some soft Velcro material to pad the inside. This made it a perfect fit.
The bar going across the middle of the window in the pictures actually broke off, so I revised the stl file to not have it at all. I posted the original file including the bar too if you would like that
The top and bottom edges of the window will need sanding after support removal.
Neighbor did not use supports to print and it came out fine, but I am worried about print quality if running supportless since I revised the file to have no bar across the middle. Not sure if supports on will mess with the HONDATA text on the side either.
Have fun! I use this as a way to secure my FP when driving my 2014 Civic SI.
Designed this in SolidWorks using a ruler to measure the FlashPro's dimensions. I chose to err on the side of too big over too small, so used some soft Velcro material to pad the inside. This made it a perfect fit.
The bar going across the middle of the window in the pictures actually broke off, so I revised the stl file to not have it at all. I posted the original file including the bar too if you would like that
The top and bottom edges of the window will need sanding after support removal.
Neighbor did not use supports to print and it came out fine, but I am worried about print quality if running supportless since I revised the file to have no bar across the middle. Not sure if supports on will mess with the HONDATA text on the side either.
Have fun! I use this as a way to secure my FP when driving my 2014 Civic SI.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!