Hooked spinner

Easy to print, just use a few lines of brim and you are good.

I printed slow 30mm/s and at 0.15mm but only because I used meltink3d glow and it is an incredibly hard filament and will just strip if you try and print too fast. That said the finish is 2nd to none and well... it glows. (blue is glow, grey is raptor pla, printed at .2mm and 60mm/s)
Grey is the original with holes too big and some symmetry errors that I fixed, also shrank the holes down to 22mm from 22.148mm.

Easy to spin due to the shape and at 7.6mm thick its on the weighty side and spins for days.
(2:20) with the right bearings.