Thingiverse
Hover:Sledge
von KeyX90
0
Downloads
1
Likes
0
Makes
This is the "snowmobile" named Hover:Sledge!
* You need to have the Hover:bit frame, code, and remote controller for this to work.
Print it with normal settings, (80 speed, 200 temp nozzle, 60-70 bed temp).
No support.
To make it slide even better, add some acetate sheets below the skis, towards the snow. Tape it to both ends, and that's it.
There are various methods to make the sledge glide even better, like waxing, wax from candles, sanding, polishing, etc.
If you do decide to print this project, please take a picture, and tag @goMakeKit on Instagram, Twitter, and Facebook.
* You need to have the Hover:bit frame, code, and remote controller for this to work.
Print it with normal settings, (80 speed, 200 temp nozzle, 60-70 bed temp).
No support.
To make it slide even better, add some acetate sheets below the skis, towards the snow. Tape it to both ends, and that's it.
There are various methods to make the sledge glide even better, like waxing, wax from candles, sanding, polishing, etc.
If you do decide to print this project, please take a picture, and tag @goMakeKit on Instagram, Twitter, and Facebook.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!