Thingiverse
Hovercraft
door CETH1182
0
Downloads
1
Likes
0
Makes
3D printed hovercraft remixer from JSCALOR to fit in a 200x200mm bed.
https://www.youtube.com/watch?v=078wIjiQIMc&feature=youtu.be
A lot of drilling to clean the small holes, I used 2mm and 2.5 mm hex screws
All can be found in amazon (I never though someone would ask me to load my remix)
1 Power distribution board = Lumeniere
2 ESC Little bee 45AMp
2 Tattu 2306 - 2400Kv Brushless Motors
1 Spectrum 4 channel Receiver
1 Servo
1 4s Battery 120 C 1550mah funfly
1 LED strip 5V.
1 Pololu power regulator
(Bullet connectors for better assembly)
https://www.youtube.com/watch?v=078wIjiQIMc&feature=youtu.be
A lot of drilling to clean the small holes, I used 2mm and 2.5 mm hex screws
All can be found in amazon (I never though someone would ask me to load my remix)
1 Power distribution board = Lumeniere
2 ESC Little bee 45AMp
2 Tattu 2306 - 2400Kv Brushless Motors
1 Spectrum 4 channel Receiver
1 Servo
1 4s Battery 120 C 1550mah funfly
1 LED strip 5V.
1 Pololu power regulator
(Bullet connectors for better assembly)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!