Slicer Discord
HydroFilter – 3D-Druckmodell von MakerWorld MakerWorld
Sport & Outdoors

HydroFilter

7 Downloads
20 Likes
1 Makes
Zum Modell
When you go camping, you can't always lug all the drinking water you need with you. Yes, some campsites provide clean water. But if your'e backwoods camping or backpacking, you sometimes need to boil water from a stream or river. boiling water kills bacteria, but doesn't get rid of bits of sand, dead bugs, etc. . That's where the HydroFilter comes in. just pour the water into the filter, and pump it into the pot or whatever you're using to boil it. then wait for the water to cool, and enjoy clean, filtered water. Thanks to the HydroFilter. The HydroFilter comes in 3 parts, put together without glue or screws. Simply slot the filter into the tank, and use the pump to push it all the way in. Then pull the pump out to fill the HydroFilter. The HydroFilter also has a handy loop for attaching a carabiner, so you can attach it to your backpack on the go. Note: It is normal for a little water to leak out of the top of the HydroFilter when pumping. If you don't like tha
Kategorie
Sport & Outdoors
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Fortgeschritten Niedrige Konfidenz
Warum?
3-teiliger Zusammenbau · aufwändige Nachbearbeitung
Hardware nötig
Supports 1/3
Zusammenbau 1/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 3/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Wood PLA
Nachbearbeitung
Schleifen, Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen