Thingiverse
Hypercube BLTouch Mount
von salfter
8
Downloads
5
Likes
0
Makes
This is a remix of the capacitive proximity sensor mount into a BLTouch mount. It should hold the sensor (not including the pin) 8.3 mm above the print bed when the nozzle is on the bed.
In your Marlin config, start with NOZZLE_TO_PROBE_OFFSET set to {25,0,-2}, home the printer, get the Z position (probably greater than 0) where a piece of paper drags a bit when pulled between the nozzle and bed, and add that to -2 to get the proper Z-value for probe offset
In your Marlin config, start with NOZZLE_TO_PROBE_OFFSET set to {25,0,-2}, home the printer, get the Z position (probably greater than 0) where a piece of paper drags a bit when pulled between the nozzle and bed, and add that to -2 to get the proper Z-value for probe offset
salfter veröffentlicht auch auf
96 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
