Thingiverse
HyperCube, E3D mount without blowing
door saschai
26
Downloads
10
Likes
0
Makes
I'm slowly collecting a new HyperCube
Last night I printed the carriage of the X-axis.
A few hours earlier was an update.
I realized this, only after the end of printing :))))).
I print ABS plastic, without blowing.
I used the idea of this holder https://www.thingiverse.com/thing:1876861 and made holder for new versions X carriage.
Adapted for ABS printing with plastic.
I'll check in live only next week, but there should not be any problems!
Last night I printed the carriage of the X-axis.
A few hours earlier was an update.
I realized this, only after the end of printing :))))).
I print ABS plastic, without blowing.
I used the idea of this holder https://www.thingiverse.com/thing:1876861 and made holder for new versions X carriage.
Adapted for ABS printing with plastic.
I'll check in live only next week, but there should not be any problems!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
