Hypercube Evolution Compact Bondtech BMG Mount (WIP)
von carb143
3
Downloads
0
Likes
0
Makes
Sort of a work in progress. I am posting the STL, STEP, and fusion 360 design file because I will no longer be using that software. Perhaps someone can remix and finish this...
I wanted to switch to a direct drive Bondtech BMG on my Hypercube Evolution with original X axis mount plate. Unfortunately all of the other mounts are either too large, too complex, or cause you to lose some build volume. This solution was intended to have the BMG mount 'backwards' with the extruder motor facing towards you. My prototype looked very promising with zero X or Y loss and about 3mm of Z loss (the motor had to be mounted a little lower to prevent it from hitting the cross member above it).
If you are starting a new HEVO from scratch, I suggest adding 5-10mm to all of the dimensions just to give yourself some wiggle room.
I wanted to switch to a direct drive Bondtech BMG on my Hypercube Evolution with original X axis mount plate. Unfortunately all of the other mounts are either too large, too complex, or cause you to lose some build volume. This solution was intended to have the BMG mount 'backwards' with the extruder motor facing towards you. My prototype looked very promising with zero X or Y loss and about 3mm of Z loss (the motor had to be mounted a little lower to prevent it from hitting the cross member above it).
If you are starting a new HEVO from scratch, I suggest adding 5-10mm to all of the dimensions just to give yourself some wiggle room.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
