Hypercube Evolution Hemera Mount

DaHai8 created a great Hemera mount. I only made a few changes to better suit my needs.

1. I added a wire groove for routing the hotend wires because I couldn't find a good way to keep them out of the way.
2. I lowered the 4 mounting post holes by about a mm to drop the nozzle closer to the bed.
3. I moved the wire post closer to the center, which made it easier to print since it no longer requires supports. It's also closer to the groove for the hotend wires making it all a bit tidy.
4. I reduced the nut trap in the center (for mounting to the X Carraige) so the nut doesn't fall out. You can partial thread the nut onto a socket head screw and push the nut into the trap, or use a screw from the other side and tighten it until you "pull" the nut in.

*note: I also include the mount with DaHai8's wire post and the hotend wire groove in case others prefer it. I'm using a cable chain so the other mount puts the wires in the center where the chain mount starts.