Thingiverse
HyperCube printable interlocking Frame
door jh1985
1.4k
Downloads
1k
Likes
3
Makes
Completely printable frame for Hypercube. As loing as you have 177mm height.
Based off tech2c recomended measurements.
*designed to print with my lasercut i3 with e3d x179 y190 z180
- Print with a 5 line or more brim.
-Print Settings
-use concentric infill unless printing solid. If solid use any pattern.
-0.3mm layer height or less. 0.3 used in the pictures
-55mm sec speed or less. Seems to get problems faster. Your printer may be different.
-Best way to attach together so far wIth PLA
1. Sand your z seam from the square pin so you have a nice fit. Make sure its flush before you glue. No gaps.
2. Use CA or epoxy Very lightly. Press firmly together.
3. Fuse or melt using a heat gun at 350 deg. I use a fine tip so i only melt a small amount. Place part on a flat surface lke your build plate. Heat the joints one side at a time rotate the bar each time while also pushing together. Make sure not to push to hard and cause a bulge. Use the flat surface to keep them strait.
(I foun
Based off tech2c recomended measurements.
*designed to print with my lasercut i3 with e3d x179 y190 z180
- Print with a 5 line or more brim.
-Print Settings
-use concentric infill unless printing solid. If solid use any pattern.
-0.3mm layer height or less. 0.3 used in the pictures
-55mm sec speed or less. Seems to get problems faster. Your printer may be different.
-Best way to attach together so far wIth PLA
1. Sand your z seam from the square pin so you have a nice fit. Make sure its flush before you glue. No gaps.
2. Use CA or epoxy Very lightly. Press firmly together.
3. Fuse or melt using a heat gun at 350 deg. I use a fine tip so i only melt a small amount. Place part on a flat surface lke your build plate. Heat the joints one side at a time rotate the bar each time while also pushing together. Make sure not to push to hard and cause a bulge. Use the flat surface to keep them strait.
(I foun
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!