Thingiverse
Hyperice Hypervolt Charging Hub
von iveslao
20
Downloads
4
Likes
0
Makes
Charging hub for the Hypervolt. It is a 3-part assembly so mix it with your favorite colors!
*UPDATE 04/22/20
Added holes at the bottom of the two lower parts for threaded inserts for better stability.
3x Insert - M3x8x5
3x Screw - M3x12
I heat-pressed the brass inserts into the holes with a soldiering iron set to the lowest temperature (~200 'C)
*UPDATE 04/22/20
Added holes at the bottom of the two lower parts for threaded inserts for better stability.
3x Insert - M3x8x5
3x Screw - M3x12
I heat-pressed the brass inserts into the holes with a soldiering iron set to the lowest temperature (~200 'C)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!