Thingiverse
Hyperion
von Tenebris_Noctus
92
Downloads
90
Likes
1
Makes
Replica of the Intamin mega coaster Hyperion at Energylandia
This being the overbanked turn underneath the lifthill.
Scaled 1/100
However for a good display size I would recommend at least scaling up to 200% (1/50) Wich is the size in the photos.
This was created for resin printing.
Naming conventions are in track direction. So viewing from the front of the model going down and left.
Track piece 1 being the highest
Support 1 being the tallest
File explanations:
Mix and match these fitting to your print volume and scale, or copy my list further down.
Train:
-Frontcar
-Midcar
-Endcar
These are split up, as the train only has 3 distinct types of cars.
The original train consists of 7 total cars so 1 front/endcar and 5 midcars.
Track:
-Hyperion_Track_v1 : The entire track, with supports as a single uncut file
-Hyperion_Track_p1 : Part 1 of the cut track without the supports
-Hyperion_Track_p2 : Part 2 of the cut track without the supports
-Hy
This being the overbanked turn underneath the lifthill.
Scaled 1/100
However for a good display size I would recommend at least scaling up to 200% (1/50) Wich is the size in the photos.
This was created for resin printing.
Naming conventions are in track direction. So viewing from the front of the model going down and left.
Track piece 1 being the highest
Support 1 being the tallest
File explanations:
Mix and match these fitting to your print volume and scale, or copy my list further down.
Train:
-Frontcar
-Midcar
-Endcar
These are split up, as the train only has 3 distinct types of cars.
The original train consists of 7 total cars so 1 front/endcar and 5 midcars.
Track:
-Hyperion_Track_v1 : The entire track, with supports as a single uncut file
-Hyperion_Track_p1 : Part 1 of the cut track without the supports
-Hyperion_Track_p2 : Part 2 of the cut track without the supports
-Hy
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
