i3 Mega Sensor Holder

The previous sensor did not align well and the filament kept breaking over time.
(https://www.thingiverse.com/thing:3069397)

So i create this new Sensor Holder.

Instructions.

1. Remove the magnet on the sensor. (this is not required)

2. Remove the screw holding the sensor arm with Magnet on the i3 Mega. (arm not required)

3. Use that screw to mount this new printed sensor holder.

4. Feed the filament into the sensor.

5. Feed the filament into the filament guide.

6. Then clip the sensor onto the post on the sensor holder.