Thingiverse
Idler clamp
door elmuchacho
4
Downloads
8
Likes
0
Makes
Thx [schlotzz](http://www.thingiverse.com/schlotzz/about) for the original design for this direct drive extruder. Mainly I did get one of the idler to break the pressure on the bearing was too great and the pin snapped I then wanted a simple add on without changing anything from the original design like this anyone who already got this extruder can use this little clamp. You'll just need to use a bit longer screw a 20mm to 25mm for the swivel and a 16mm to close the idler and clamp together.
Ps/NOTE: I should have checked the remixe as someone else as done something similar but this one came up from the depth of my imagination.
Ps/NOTE: I should have checked the remixe as someone else as done something similar but this one came up from the depth of my imagination.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
