Thingiverse
Idler Mounts - Hyperstack
por TheGreatGrezzy
0
Descargas
1
Likes
0
Makes
I designed these Idler Mounts for my custom 3d printer based on the Hypercube called the Hyperstack!
These align with the motor mounts and XY Joiners to keep the belts as flat and aligned as possible. They use some small pulleys with a screw that runs the length of the piece as an axle.
Check out my blog for the design process for this printer!
My blog
Full Printer is still WIP, but will get done.... eventually....
XY Joiner
X Carriage
E3d Mount
These align with the motor mounts and XY Joiners to keep the belts as flat and aligned as possible. They use some small pulleys with a screw that runs the length of the piece as an axle.
Check out my blog for the design process for this printer!
My blog
Full Printer is still WIP, but will get done.... eventually....
XY Joiner
X Carriage
E3d Mount
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
