Thingiverse
Igloo BXM cooler drain plug cap
por drthumbs
11
Descargas
15
Likes
0
Makes
This is a replacement drain plug cap for a Igloo BXM cooler. It may also fit other Igloo cooler and even other brands, but that has not been tested.
Threads are tighter than original, but operate smoothly.
The addition of a 26mm OD O-ring or other gasket is required to guarantee seal. There is a gap in the bottom of the threads that will accommodate up to a 5mm O ring or other seal A couple of coats of a rubberized spray, such as Plasti Dip it is recommended on the outside. This improves grip on the knob, and the tactile feel
Print with the opening up and you should not need supports. Supports on threats my prove impossible to remove while maintaining function of the threads
Threads are tighter than original, but operate smoothly.
The addition of a 26mm OD O-ring or other gasket is required to guarantee seal. There is a gap in the bottom of the threads that will accommodate up to a 5mm O ring or other seal A couple of coats of a rubberized spray, such as Plasti Dip it is recommended on the outside. This improves grip on the knob, and the tactile feel
Print with the opening up and you should not need supports. Supports on threats my prove impossible to remove while maintaining function of the threads
drthumbs también publica en
2 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
