Thingiverse
Impossible Table
por ScoobaSteve451
4
Descargas
7
Likes
0
Makes
My take on the impossible table
Hardware needed:
(6) M2 x 10mm bolts
(2) M2 x 12mm bolts
(8) M2 nuts
You will need to print (63) links to complete the chains (3) for the center and (10) each for the outer. I found it most effective once the chains are assembled to "weld" each link with a drop of CA glue, you could also use heat to close the gap in each link.
You will need to print (12) of the anchors to complete the chain assembly.
Hardware needed:
(6) M2 x 10mm bolts
(2) M2 x 12mm bolts
(8) M2 nuts
You will need to print (63) links to complete the chains (3) for the center and (10) each for the outer. I found it most effective once the chains are assembled to "weld" each link with a drop of CA glue, you could also use heat to close the gap in each link.
You will need to print (12) of the anchors to complete the chain assembly.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!