Thingiverse
Infinity Cube
door dschoeni
302
Downloads
191
Likes
1
Makes
The cube is built out of 2 different parts.
Print every part 3 times, so you have 3 + 3, then connect all together.
The bolts on one side can be monted in the hole of its opposite part.
It should fit together with low pressure, if printed with the appropriate settings.
If the parts are too loose, you could add some plastic glue ...
Print every part 3 times, so you have 3 + 3, then connect all together.
The bolts on one side can be monted in the hole of its opposite part.
It should fit together with low pressure, if printed with the appropriate settings.
If the parts are too loose, you could add some plastic glue ...
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!