Ink tray

Ink/paint display for max 23 mm tubes.

Build:
You need to glue the parts. It's pretty simple.
The sides have supports on each side to hold 1 row of 5 tubes.

2 rows have a little support plate so the row that goes on top can rest on it.
1 row with support goes on the bottom and the other one goes above that one.
The one with no support plate needs to go on the highest place.

I sanded the parts that needed to be glued a bit and then used superglue. Steady as a rock.


Print settings:

Infill: 30% 
infill pattern: Triangles

I used no supports because I didn't wanted to waste filament.
But if you want the support/glue plates to be more clean, you can add supports.