Innogy program adapter

I created some adapters to reflash Innogy smart home products with new software. All adapters use 2mm pointed pogo pins. Some adapters are modular, you can insert the pogo pin adapter into the holder mathcing the hardware.

Howto:
- print adapters with 0.1mm layer height
- Solder the ribbon cable to the pogo pins
- Insert the pogo pins into the adapters. They should have a press fit. Glue them in with a tiny drop of superglue.
- Wait for the glue to dry.

Flashing:
- Insert the adapter block into one of the holders. Attach the holder to the dismantled device.
- Attach the ribbon cable to the programmer.
- Insert the programmer into your computers USB.
- Flash the firmware with avrdude or avrdudess.