Thingiverse
Insta360 x3 Loop Mount
por Secret-Asian-Man
9
Descargas
20
Likes
0
Makes
- Sliced with CURA.
- Print with 100% infill.
- Print with support at 36 degrees. Screw may need some light cleanup, but screwing it in the camera should re-tap it.
- Recommended to print with a brim.
- Takes about 30mins to print with my slow settings.
- Not tested with PLA, but should work fine.
- Print with 100% infill.
- Print with support at 36 degrees. Screw may need some light cleanup, but screwing it in the camera should re-tap it.
- Recommended to print with a brim.
- Takes about 30mins to print with my slow settings.
- Not tested with PLA, but should work fine.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!