Slicer Discord
Intel NUC - Stack Ring – 3D-Druckmodell von Thingiverse Thingiverse

Intel NUC - Stack Ring

von tophe75
92 Downloads
71 Likes
2 Makes
Zum Modell
If you are like me, you like to mess around with computers.
I also like to have my own Virtual Lab and in order to control heat, I came up with this ring, as the Intel NUC sucks air in from the bottom and blows it out in the back.

If you want to build your own Nano Lab there is an excellent guide about it here (not by me): http://www.tekhead.org/blog/2013/01/nanolab-running-vmware-vsphere-on-intel-nuc-part-1/

As of now my Nano Lab runs on three VMWare hosts (two of them Intel NUC's) and also iSCSI LUN from my NAS (Synology 414) all connected through a Netgear GS108Ev2 switch with multiple vlans.

Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
50 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

tophe75 veröffentlicht auch auf

9 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen