Slicer Discord
Interactive UnderScreen Pi Pico ( + Moku Version) – 3D-printbaar model van MakerOnline MakerOnline
Interactive UnderScreen Pi Pico ( + Moku Version) – Bild 1 Interactive UnderScreen Pi Pico ( + Moku Version) – Bild 2
Household

Interactive UnderScreen Pi Pico ( + Moku Version)

0 Downloads
0 Likes
0 Makes
Model downloaden
I try to release new models every week!     Join my Patreon! It's very big support for my work, and it's free ! 😊 https://www.patreon.com/cw/DSCMaker     NO SCREW only one Pico 2W, cable and ILI9488 SCREEN (All with print cost under 15$)   Upgrade your workspace with a sleek, modern desktop companion designed to fit perfectly under your monitor. This standalone interactive device connects over Wi-Fi to log your tasks to Toggl Track in real time. Plus, it's open for customization write your own code or load custom software to completely personalize your experience like macro button or weather station… Featuring a premium, minimalist design with a signature striated/knitted texture, it blends effortlessly into any modern clean-desk setup.   ✨ Features Clean & Modern Aesthetic: Beautiful knitted/striated texture profile with a perfectly angled display for visibility. 100% Screwless Assembly: Everything snaps together snugly no hardware needed besides a RPI Pico and Screen (Less than 15$). Compact Footprint: Low-profile design made to sit neatly beneath your screen. Fully Standalone: Powered by a Raspberry Pi Pico   🛠️ Hardware Required 1x Microcontroller: Raspberry Pi Pico 2W (I used a RPi Pico with male pin headers to connect the Dupont jumper wires, but you can also solder the wires directly to the board if you prefer) 1x Display + Touch: ILI9488 3.5" TFT LCD Display with Touch (ILI9488 driver + XPT2046 touch controller) 13x Dupont Line: Female-Female and Male-Female (Minimal) 1x Connectivity: Micro-USB   🚀 Print Settings Supports: Minimal tree supports Infill: 10% Gyroid. For assembly: Wire the screen to the RPi according to the schematic. Place your Pico onto the bottom cover and slide the clip into place. Make sure your Micro-USB port remains accessible when your cable is plugged in. Insert the screen into its slot. Gently press the clip onto the clear area at the back of the LCD (where there are no soldered components). Do not push too hard, as excessive pressure
Categorie
Household
Bron
MakerOnline
Gepubliceerd
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

DSCMaker publiceert ook op

59 extra modellen op 2 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie