Thingiverse
Invertible Cube, Hinged Version
door lgbu
10
Downloads
6
Likes
1
Makes
####Paul Schatz’s Invertible Cube, Hinged Version
##### Edge Length 75 mm
Schatz’s Invertible cube is simple and mathematically appealing. I wanted to add some hinges and make a long-lasting model, to be printed with PLA. Well, I managed to add the hinges but had a lot of trouble, trying to figure out a way to print it in one piece. With enough support and/or 3D manipulations, it is possible to print it on a good printer. However, I have not had much luck. I will upload the file and leave the challenge to other creative minds.
Meanwhile, I decided to slice it using the hexagonal plane within the cube. **Big surprise!** I got six pairs that are essentially the same. So one can print six copies and GLUE them together. To help with alignment, I added a square pin. **Using the tight version of pins, one can just snap the pieces together for an invertible cube**. Of course, a few drop of glue will help in the long run. And the pins are optional if you have so
##### Edge Length 75 mm
Schatz’s Invertible cube is simple and mathematically appealing. I wanted to add some hinges and make a long-lasting model, to be printed with PLA. Well, I managed to add the hinges but had a lot of trouble, trying to figure out a way to print it in one piece. With enough support and/or 3D manipulations, it is possible to print it on a good printer. However, I have not had much luck. I will upload the file and leave the challenge to other creative minds.
Meanwhile, I decided to slice it using the hexagonal plane within the cube. **Big surprise!** I got six pairs that are essentially the same. So one can print six copies and GLUE them together. To help with alignment, I added a square pin. **Using the tight version of pins, one can just snap the pieces together for an invertible cube**. Of course, a few drop of glue will help in the long run. And the pins are optional if you have so
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
