Thingiverse
iPad_Case_Support-Bracket
por Gundy2
2
Descargas
0
Likes
0
Makes
Replacement for broken part on iPad protective case made by SUPCASE. Sliding part of support designed to fit on back of case and lock in using 0.8 mm metal wire shaft (about width of small paper clip). Requires one 36.5 mm long and 40.3 mm long wire shaft to thread through holes at each end of printed part.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
