iPad Pro Riser or Tilted Stand

Made this stand for my 11 inch iPad Pro m4. Allows me to use it when I have my keyboard case on it and without the case, using the adaptor and removable ledge. The profile has a plate for each part, but if you wanted you could print it in two plates. I didn't want to worry about having a corner lift off, so I printed each piece by itself. The adaptor and top piece are free to rotate fully around the base, allow you to position it how you want. I have a notch in the adaptor that keeps the top plate from tilting left or right (As can be seen in the pictures). The gap between the top plate and ledge is 7 mm. If your iPad or tablet is that thick it should work. When using it in the angled position, it is 6 inches to the bottom and 10 7/8 to the top. When it is flat it measures 6 3/8 inchs tall. Top plate is 7 7/8" wide by 6 1/16" deep. I tried to keep the tolerances pretty tight as I didn't want to risk my iPad from falling. I didn't have to do any sanding when I printe