iPad Stand

I needed an iPad stand so I designed one. I initially designed it to be printed upright. If this fails, I've also split it in the middle and added 1.5mm holes to place dowel-pins in and put it together post-print. I'm currently printing the upright version, but there are some serious overhangs so we will see how it works. I'm going to print test dowels to see what size is best, and after that's done I'll upload a model of the dowels to print.

Upright V2: Added leg supports in middle of rear-support to assist with upright printing.

This design may be more of a torture test than a functional item, but I can confirm my Ender 5+ printed this with minimal sagging and stringing.