Thingiverse
iPad Stand
von cerealkillers
6
Downloads
5
Likes
0
Makes
Based on https://www.thingiverse.com/thing:1464340
When I first printed that thing I thought it was way too big for a phone. I found I needed to scale that thing 66% in all three axes to make it suitable but...
At 100% size it works really well for an iPad however you can't put the iPad in vertically without risk of it falling backwards. This adds another little notch so you can either have the iPad reclined (for stuff like Facetime on a table) or more vertical (for recipes in the kitchen perhaps).
Prints really nicely in PLA on my i3 MK3 with 0.2mm Quality profile.
When I first printed that thing I thought it was way too big for a phone. I found I needed to scale that thing 66% in all three axes to make it suitable but...
At 100% size it works really well for an iPad however you can't put the iPad in vertically without risk of it falling backwards. This adds another little notch so you can either have the iPad reclined (for stuff like Facetime on a table) or more vertical (for recipes in the kitchen perhaps).
Prints really nicely in PLA on my i3 MK3 with 0.2mm Quality profile.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
