Thingiverse
Gadgets
Go to Model
ITX case
142
Downloads
165
Likes
0
Makes
Every piece can be printed on a 220mmx220mm bed
This is the fist thing I've designed so any feedback would be much appreciated
GPU mounting needs to be glued, only done so things can be printed with minimal supports
Feet are designed to be printed out of flexible plastic and pushed into the bottom panel it will require 2 of the feet to be mirrored in when sliced
Fixings I used to screw everything together
https://www.amazon.co.uk/dp/B075WY5367?psc=1&ref=ppx_yo2ov_dt_b_product_details
The nuts may need a drop of glue to hold them in but can be fine without
If I change anything it will be to fix where the front panel attaches to the bottom panel to make it the same as the top
This is the fist thing I've designed so any feedback would be much appreciated
GPU mounting needs to be glued, only done so things can be printed with minimal supports
Feet are designed to be printed out of flexible plastic and pushed into the bottom panel it will require 2 of the feet to be mirrored in when sliced
Fixings I used to screw everything together
https://www.amazon.co.uk/dp/B075WY5367?psc=1&ref=ppx_yo2ov_dt_b_product_details
The nuts may need a drop of glue to hold them in but can be fine without
If I change anything it will be to fix where the front panel attaches to the bottom panel to make it the same as the top
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
