Thingiverse
J1Sys P2 In case base
door Lithgowlights
0
Downloads
1
Likes
0
Makes
A simple base to allow mounting of the J1Sys P2 Pixel Controller in the aluminium case, onto a board or backing plate. This uses tow of the case end bolts to mount to the case. You may need to elongate the holes slightly to fit the P2's bolts in, depending on your printers accuracy.
This was printed in ABS, but PLA is fine
This was printed in ABS, but PLA is fine
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
