Thingiverse
SanDevices E6804 case
von Lithgowlights
6
Downloads
2
Likes
0
Makes
SanDevices E6804 SACN/E1.31 RGB Pixel Controller base. Printed in ABS, but PLA is fine as well.
I have slightly modified the opening for the power cables since the print was done, allowing more room on the left and top.
I have slightly modified the opening for the power cables since the print was done, allowing more room on the left and top.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
