Jacket hanger

Design ConceptWall support to slide on hanger for jackets or capsUsageuse 2 screens to set thesupport in the wall, recomed to use a dowel in each, the simply slide in the other part on.The hole for the screens are 1.8mm(narrow end back end) - 3,5mm(front wide end)Printing TipsSuggested material: PLA or PETG for durability.Recommended layer height: 0.2 mm to ensure strength while maintaining a good finish.Infill: 30% for adequate support while keeping the print lightweight.Assembly InstructionsNo assembly required, ensure the print is cool and handle with care immediately after printing.