Jerry Mouse

Jerry Mouse, a cartoon character from the "Tom and Jerry" series of short films created by Hanna and Barbera for MGM. The series features comic fights between an iconic set of adversaries, a house cat (Tom) and a mouse (Jerry). The plots of each short usually center on Tom's numerous attempts to capture Jerry and the mayhem and destruction that follows. Except for the body, no other supports are required. See the notes section for where to place the supports in your slicer. If you have the proper filament colors, no painting is needed. The assembled model is 200mm tall. Jerry does not stand by himself without a base, which is included as a separate model The base for the Tom and Jerry models: https://www.printables.com/model/536761-base-for-tom-and-jerry The full Tom model: https://www.printables.com/model/518371-tom-cat   Enjoy! ....................................................................................................... Special shoutout to maker Benoît Lussier for providing QA printing and quality feedback. ........................................................................................................... **Print Instructions:** Supports: Only body.stl requires some supports, see notes Resolution: .2mm Infill: 15% *************** For all my models: Do not enable 'Detect bridging perimeters'. This is a parameter that PrusaSlicer 2.6 enables by default. Do not enable 'thick bridges' Do not set 'arachne' for perimeter generation. PrusaSlice selects this option this by default Do not enable 'detect thin walls'.  *************** .... Refer to the notes below for a few helpful printing and assembly instructions. ........................................................................................................... **Building the model** Colors Black: (Paramount3D PLA - Black) eye_black_right eye_black_left whiskers_right (contains two identical pieces) whiskers_left (contains two identical pieces) nose mouth_black eyebrow_right eyebrow_left eyelash