Thingiverse
Jeti Test Sensor Box
von AlastairC
1
Downloads
2
Likes
0
Makes
A box to hold the Jeti Test Sensor by Tero: at https://www.rc-thoughts.com/jeti-test-sensor/
Super simple... just build the sensor. Bolt the pot and switches in and then glue the lid on!
I used some liquid electrical tape to insulate the electrical components from each other and a 3.18x6.35mm grommet for the servo wire going through the box.
Super simple... just build the sensor. Bolt the pot and switches in and then glue the lid on!
I used some liquid electrical tape to insulate the electrical components from each other and a 3.18x6.35mm grommet for the servo wire going through the box.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!