Joined Boxes

These are two joined boxes that fit into long, narrow spaces, but each box is sized to print on an A1 mini plate. The outside dimensions of each box is 160mm deep by 115mm wide by 100mm tall. The front box has a cutout to make it easier to access the items in the box. The inner dimensions of each box is approximately 142mm deep by 107mm wide by 96mm tall. The joint is a bit loose to make sure that it can be joined even with variations in printing, which may fine depending on how you want to use it. If you need to make sure it doesn't slip, you can use small amount of glue or a couple of bits of paper inside the joint to keep it in place. One caution. The supports can be very difficult to remove and will require a set of very small needle nose pliers or an awl to push the supports out of the groove. If you enjoyed this print you can support my work and buy me a coffee (or some new filament) 😁💜