Joint container - Joint case

You can make your joint at home and transport it safely to your special place to enjoy it. If you plant to smoke where there are harsh weather conditions like rain or high winds, you just prepare the stuff at home and bring it with you in this simple case.NO SUPPORTS NEEDED, just print the cap and the case in positions like shown on the slicer photosI uploaded.It is made to carry a big joint 15cm (6 inch) but you can scale it up or down if you need smaller or bigger case.The print can be printedwithout supports, only the brim on the case itself because it is a high item with low surface to the bed.I printed in pla with 100% infil., with layer height of 0.16 and the thread works perfectly, you just have to remove the brim after the print and screw thecap few times on and off so the plastic removes tinyimperfections from print and after it works absolutely perfect.Both cap and the case take only 26 grams of filament.Enjoy!